Replacing Your Sliding Glass Door Rollers

If the sliding glass doors in your home are more than 10 years old, you might notice that they are becoming harder to slide open. This problem is even more common on aluminum frame dual pane doors. The reason is because the doors are heavier due to the dual pane glass, but many of the aluminum units did not use stainless steel rollers. So, in many cases, the rollers get rusty from moisture and they start to bind.

In order to replace the rollers, you have to remove the sliding panel from the opening. In most instances, the fixed panel must be removed in order for the sliding panel to come out. There is a simple way to determine whether or not your fixed panel has to come out as well. If the slider is on the inside track and the fixed panel is on the outside track, you have to remove both panels, because the slider will only come out from the outside. There is a lip on the bottom of the track inside your house. That lip keeps water from coming in. Unfortunately, that lip is also too high to lift the sliding panel up and over. So, you have to remove the fixed panel first, then lift and swing out the slider from outside. If you are one of the few people who have a slider on the outside track, then you can lift your slider out without removing the fixed panel.

But, let's assume you need to remove the fixed panel first. Here is what you do: Remove your screen door if you have one. The screen door will have two rollers on the bottom. Lift one end of the door frame with one hand while using a flat screwdriver to lift the roller off the track. Do that on both sides, then take out the screen door and set it aside. Now, look for a metal piece on the bottom track that runs from the bottom corner of the fixed panel all the way across to the bottom of the side jamb that has the door lock hardware. If your door is really old that piece might be missing. If you have one, you can pry it up from the track. It is snapped in place even though it looks like it is a part of the track. Once you have that piece removed, you want to look inside the house where the fixed panel is against the wall jam. Look for screws holding the frame to the jam. They usually have one near the top and bottom corners, and one near the center. Remove these screws and put them where you won't lose them. Now, you should be able to pull the fixed panel out of the side jam. There is a very good chance that it will be stuck. If it is, grab the center rail near the bottom and lift up as hard as you can. If you feel the panel go up, pull it back down. Do this a couple of times, then try to pull it out of the side jam again. This usually loosens it enough to pull it out. If it still won't come out, you will have to put a thin screwdriver between the fixed panel frame and the side jam and pry while a helper pulls the panel away from the jam. Once you get it free of the side jam, grab the fixed panel side rail and have a helper grab the other rail. Lift the panel up into the top track and swing the bottom out of the bottom track. Remove the panel from the top track and set it aside with the screen door.

Now, you can try lifting the slider up and out, just like you did with the fixed panel. If the slider won't clear the bottom track, you need to do a couple of things. First, look to see if it's the old rollers protruding from the bottom that is preventing the door from coming out, or if the actual bottom of the door frame is hitting the track. In almost all cases, it will be the old rollers. But, if the opening is 8' wide, sometimes the wood header that runs across the opening has sagged just enough to make it tight in the center of the opening. If it's the rollers, you need to adjust them all the way up into the door. Look for a hole on the bottom side where you can put a phillips screwdriver and find the adjustment screw. Then turn that screw counterclockwise as far as you can. Do that to both sides, then try lifting out the door. If you are still getting stuck, have your helper lift one side and pull outward while you try to pry the frame and roller over the track. If you get one side out, have your helper hold that side with his or her foot to prevent it from going back in while he or she lifts the other side for you to pry free.

Once you get the slider out, almost all rollers are held in place by the same screw that holds the frame corners together. So, you need to set the panel on one side, remove the screw in the corner, flip the panel over, remove the screw on the other bottom corner. Now, you can take a rubber mallet or the wood handle of a hammer, and tap the bottom frame off the glass. This will give you access to your rollers. Take a close look at how they are inserted into the door frame. In fact, it's a good idea to only remove one roller to bring with you to match for the new ones. Then, when you get back home, you can use the roller that is still in place as a guide to installing the new ones.

Places like Home Depot, Lowes, and Ace Hardware carry about 80-90% of the rollers out there. So, you should be able to find them. However, let's say this just isn't your lucky day, and you can't find your rollers anywhere. You are going to have to have them ordered. Bring the roller to your local glass shop. If you're lucky, they will have them in stock. If not, they can order the rollers, but you won't get them for about a week. Don't panic. Just go home and tap the bottom frame back on the door panel, but leave the corner screws out. You can even leave the roller out that you removed. Lift the door back in place, install the fixed panel but don't snap the bottom piece back in, and don't install the inside screws. Then, from inside the house, lift the slider and pull it closed. You don't want to drag it if you left the roller out. It will scrape the bottom track. Just lift it enough to take the pressure off, and close and lock it.

When Your new rollers come in, take everything back out and install the new rollers. Adjust the new rollers all the way up before putting the door back in. That way, the new rollers won't interfere with you lifting it back in place. Adjust the new rollers down until the door slides good and locks. You want to be sure there is an equal gap at the top and bottom when the door is about an inch from closing into the side jam. You can adjust the rollers to make this dimension even. If you can get the job done by a professional for $50 or $60 including parts, it might be worth hiring someone to do it. But, in high population areas such as Los Angeles, it's common to pay $100 in labor only. Then they mark up the cost of the rollers, and you could wind up spending $130 for a job that you can do yourself for about $20. Next week i'm going to tell you how to repair your broken or defective window glass.

John Rocco has been installing replacement windows since 1978. To learn more, visit How To Install Windows

---

Google News Updated : Sun, 12 Oct 2008 05:51:03 GMT Van driver's work in Mass. aided Nobel winners - Boston Globe Voice of America Van driver's work in Mass. aided Nobel winners Boston Globe - 1 hour ago HUNTSVILLE, Ala.—When two American scientists won a Nobel Prize this week in chemistry, the driver of a car dealership's courtesy van had reason to take special interest. Video: Nobel Chemistry Prize Goes for Jellyfish Protein AssociatedPress Comment by Jeremy M. Berg, Ph.D., Director National Institute of General Medical Sciences The Daily Yomiuri - The Associated Press - Los Angeles Times - WTEN all 1,250 news articles Publ.Date : Sun, 12 Oct 2008 04:14:18 GMT Five killed in New York fire; 300 acres burn in Napa Valley - Austin American-Statesman CBS News Five killed in New York fire; 300 acres burn in Napa Valley Austin American-Statesman - 1 hour ago NEW YORK - A family of five, including three children, died in a blaze that filled an apartment with thick smoke and kept the victims from escaping through the front door, fire officials said. Napa County wildfire forces evacuations of over 100 homes Los Angeles Times Fire Threatens Napa Valley Homes and Wineries New York Times KEYC - CBS 5 - San Francisco Chronicle - WSBtv.com all 422 news articles Publ.Date : Sun, 12 Oct 2008 04:27:05 GMT On the trail to the White House - Fort Worth Star Telegram The Age On the trail to the White House Fort Worth Star Telegram - 33 minutes ago Sen. Barack Obama, Democratic presidential nominee, at a rally in Philadelphia on Saturday. AP/ALEX BRANDON Today’s headlines Report stings Palin over troopergate flap; Raw anger showing up in McCain crowds, candidate taking steps to minimize it; ... McCain Asks Supporters to Show Obama Respect Wall Street Journal Obama Thanks McCain for Urging Supporters to be Respectful Voice of America Washington Post - Chicago Tribune - ABC News - Bloomberg all 733 news articles Publ.Date : Sun, 12 Oct 2008 05:17:46 GMT Bush, allies seek to calm jittery investors - BusinessWeek Bush, allies seek to calm jittery investors BusinessWeek - 4 hours ago By JENNIFER LOVEN and MARTIN CRUTSINGER President Bush and financial leaders from nations rich and poor pledged Saturday to intensify their efforts to unblock a frozen financial system before it does more damage to an increasingly shaky global economy. Bush Says US Must Take Lead in Solving Crisis (Update3) Bloomberg Bush, allies seek to calm jittery investors The Associated Press New York Times - Austin American-Statesman - AFP - KSFY all 1,542 news articles Publ.Date : Sun, 12 Oct 2008 01:30:21 GMT Singer Lisa Marie Presley gives birth to twins - The Associated Press The Associated Press Singer Lisa Marie Presley gives birth to twins The Associated Press - 3 hours ago LOS ANGELES (AP) - Lisa Marie Presley is a mom again. A publicist says the 40-year-old singer gave birth Tuesday to twin girls, whose names were not released. Lisa Marie Presley delivers twins: report Reuters Today's News: Our Take - Lisa Marie Presley Gives Birth to Twin Girls Seattle Post Intelligencer E! Online - People Magazine - Monsters and Critics.com - Hollywood.com all 569 news articles Publ.Date : Sun, 12 Oct 2008 02:11:28 GMT Theatrical Review of Body of Lies - DVDTOWN.com Theatrical Review of Body of Lies DVDTOWN.com - 5 hours ago By Jason P. Vargo "Body of Lies" is a certain type of movie designed for a certain type of moviegoer. I think the tagline describes the movie perfectly, actually. Body of Lies E! Online 'Body of Lies': Desert Norm, By Kurt Loder MTV.com Boston Herald - Los Angeles Times - Radar Online - Entertainment Weekly all 1,041 news articles Publ.Date : Sun, 12 Oct 2008 00:19:39 GMT McCain supporters face uphill climb in blue Jersey - Newsday Sunday Times.lk McCain supporters face uphill climb in blue Jersey Newsday - 15 hours ago By WAYNE PARRY | AP Writer WOODBRIDGE, NJ - Walter Zjawin is trying to help John McCain do what no Republican has done in 20 years: win a presidential general election in New Jersey. Maine now on McCain radar Central Maine Morning Sentinel McCain inches closer in Saturday's Gallup Kansas City Star Boston Globe - CBS News - Washington Post - Ethiopian Review all 220 news articles Publ.Date : Sat, 11 Oct 2008 14:04:37 GMT Rss Feed Reader Increase Online Traffic

PARLOT::Ebooks, Scripts, Websites, and more...

Adsense websites

Roof Cleaning - Making Your Old Roof Look Like New!

Many Florida residents that have come from the North are... Read More

Physiological Response to Window Coverings

Nothing soothes the brain like Mother Nature, whose intrinsic scenery... Read More

Remove Carpet Stains - The How To

Your short lesson on how to remove carpet stains: act... Read More

Chester Conservatory Build Process

1. The site of the proposed conservatory.2. Construction work begins.... Read More

Asphalt Paving Driveway Maintenance Tips

Asphalt paving or Hot Mix Asphalt is typically what one... Read More

Installing Retrofit and Replacement Vinyl Windows

In previous articles i explained to you how to determine... Read More

Why You Might Need a Waterproofing Consultant

Waterproof consultants perform a wide variety of functions. Why should... Read More

Bamboo Flooring Is Taking The Design World By Storm

Are you looking for something different for your house? Maybe... Read More

Which Type of Radiant Floor Heating is Best For Me?

If you are looking to warm your floors with a... Read More

Whats Underfoot? A Quick Guide to Patio Surfaces

Patios and terraces have always been popular outdoor spaces. Whether... Read More

How to Modify Your Landscaping to Protect Your House from Burglars

Believe it or not, landscaping can be an important part... Read More

Flooring: Installing Ceramic Tile

Ceramic Tile brings a texture, richness and color to a... Read More

Designing Great-looking Window Coverings on a Budget

Window coverings are one of the most important focal points... Read More

Warm & Toasty Outdoors with Patio Heaters

The Heat is On with... Read More

Maintaining Your Hot Tub

Purchasing a hot tub is a big investment and one... Read More

The Wireless Home

It was only a few years ago that Real Estate... Read More

Rustic Stone House Signs

You may own a remarkably constructed, attractive house that is... Read More

Soy Candles? What Will They Think of Next?

Quick: What comes to mind when you think of soy... Read More

Types Of Bedsteads

Selection of bedstead is also an important thing as selection... Read More

Pool Decks ? Add Ambiance to Your Above Ground Pool

Above ground pools are beloved by many and have gained... Read More

So Youve Decided to Finish Your Basement!

When a family decides to finish a basement space, there... Read More

Eclectic Patio Furniture Shows Your Style

Your home's interior is exquisitely decorated in your favorite style;... Read More

Make your Sauna a Focal Point

A sauna has been used throughout history in every part... Read More

Use the FHA Mortgage Specifically Created for Home Improvement

Almost everyone knows about FHA mortgages. They are tailor-made for... Read More

Laminate Flooring - Cleaning & Maintenance

One of the biggest advantages of laminate floors is that... Read More